94 100 CS w/electrical woes
#1
94 100 CS w/electrical woes
Hi, I just bought a 100 CS with a bad clutch. Finally got done replacing the clutch and when installing the gear box, I pinched two wires (that contain three smaller wires inside) and now the car will not start. It started the before the clutch job, and the wires go to a five wire bracket attached to the firewall on the passenger side. They are the two closest to the center of the car. Could these possibly be the crank shaft position sensors? The engine turns fine, but I have absolutely no spark. Please help, I am 150 miles away from home and this is approaching a week job now. Any information would be appreciated, thank you very much...!
Pfunk
Pfunk
Thread
Thread Starter
Forum
Replies
Last Post
ditobot
Audi A6
8
02-06-2012 10:51 PM