Ok so im looking to get one of these 3 things... eventually im getting a boost gauge and stage 3 modshack... just dont know where i should start...

 

Since you are already chipped it's essential you get a boost gauge ASAP.
There's really no other way to tell when you get a boost leak, except by looking at your boost gauge.

 

ttda, cold air is good air.

boosts gauge is good, but independant of whether you're chipped or not. i wouldn't spend that much on a gauge.

 

for the ttda dont i have to take off my front bumper or something? to run the inlet hoses?

 

no. the inlet feeds aren't necessary immediately. You can run just the TTDA now, and later down the road you can run the feeds once you get a FMIC. I have a VTDA, but if I were you... I'd go TTDA rather than VTDA or boost gauge. honestly, a boost gauge with all hardware and setup is only about $65

 

Whats the diff between a TTDA & VTDA.

 

Descriptions of the two are here: www.modshack.info

 

You can get a boost gauge w/ vent ring and a k&n or simular drop in filter for about the same if less than the intakes. Plus you will see all the same "gains".

 

couple more votes? im on the edge still

 

I like my recommendation best....I DONT KNOW WHY...?