I currently have 18x8 aftermarket wheels wrapped in 235 rubber on a 2002 1.8 a4 with no suspension mods at this point.. was looking to do a wheel offset for a slighty wider stance.. the aftermarket wheels did help but i wouldnt mind a bit more.. i was lookin on ecstuning but wasnt sure what kind of limit i have without having any kind of rubbing issues.. i tryed searching but a had little luck with b6's.. suggestions??

Are you wanting the wheels to sit right inside the fender (almost touching)?

most people are goin wit a 35 offset

PandaXpress is right ... 35 is what I'm hearing

ORIGINAL: SouthernAudi

Are you wanting the wheels to sit right inside the fender (almost touching)?


Yeaa basically as wide as i could without rubbing issues..

Hmm so i would need to purchase a 15mm offset then so to achieve the 35 mm offset? idk if im doin the math right lol.. cuz i was lookin at some on ecstuning and they got sizes up to 20 i wanna say..

nvm 15 is too much lol.. any help?

et 35, look at some of the side pics of my car with the oettingers on it. They are et35 and sit almost flush

Hmm that is a good look exactly what i want.. any idea whay stock offset is on a b6?

Did some research and found out my wheels have a +38 offset so im gunna get 5mm spacers to achieve a +33 offset all around..

thanks for the input guys!