So my 1 Pc. E-codes are comin in tommorow, and im just wondering how much of the fender am i going to have to cut in order for these to fit? Anyone got any pics that i could take a look at? Very excited for the updated look

 

?

 

Probably a 1/4-1/2" will have to be ground out. make sure you have some touch up paint handy to paint the exposed metal.

 

I didn't use touch up paint ( dealer was closed ). I just went to PepBoys and got some spray clear and used it. I have recut them a few times to get them to where I wanted them and sprayed each time. I just taped off the fender and covered it with newpaper before cutting and spraying to protect the rest of the fender. I am very happy with how they look now. I cut it all the way back to the bend and the headlights sit all the way back there now. If I was to do it again on new fenders I might leave about a 1/16 of a inch before then bend.

hope that helps,

Enjoy,

 

finally got them in today and im looking at the wiring and it shows that there are only 3 wires? High beam positive low beam positive and a ground? thats easy. Im stillnervouce about the fender

 

Just take it slow and you'll be ok.

 

take away a little at a time man... it's REALLY hard to mess this up. but like they said, definatly have some paint on hand, last thing you want is to be coating paint over moisture. That's about the only place you can really mess up... the fender trimming doesn't HAVE to be perfect... just decient. any little imperfection will be covered by the headlight anyway

 

since i work at a dealer with a body shop, im gunna pay a body shop guy 20 bucks do to the cutting and painting. figure its better if he messes up than me haha. the rest ima do

 

i'd pay 20 bucks to have it done if the option was there too...

 

yeah, you lucked out there man