Good Afternoon,
I have an 2004, A6, 2.7, all wheel drive audi. My turn signal is not blinking just stays on. I looked at the fuse box and there was nothing in there for turn signals. What would this require?

 

Usually means you need to replace the hazard switch (the red triangle in the middle of your dash) because that is where the blinking signal comes from.

 

OR

the blinkers are low on blinker fluid

Blinker Fluid - $18.95 : KaleCoAuto.com, Your home for the rare, unusual, and hard to find auto parts.

that there is "audi approved synthetic"

 

Have you checked that all the bulbs are working, if a bulb is burned out that side blinker is just going to stay on without blinking.

 

Wouldn't it normally flash really fast then?

 

That's PFM!

 

BTW, Ditto on the hazard switch.

 

Hi there
Any one have a answer for why my indicators not bling stay steady,I checked the fuses,check the relays but not shure which is the right to replace,there is more than one location for relays one is on front under bonett second straight under drivers panel where the fuses located.any replay will be apriciatted