p0300 misfire code..suggestions?
#1
p0300 misfire code..suggestions?
okay my car has been running intermittantly in limp mode for about 2 weeks now, i replaced both EGT sensors last feb so it couldnt have been those but anyway i took it to the mech today and had him pull any codes and came up with p0300 and he said it was a misfire code and he said it for sure would cause the car to run in limp mode. he said it could be a number of things, bad plugs, vacuum line, ect. it would cost 85 dollars for them to diagnose it so i was like screw that ill ask here first for places to look. i ran sea foam yesterday through my intake and it didnt cause any other codes so i guess thats good but just restating this has been happening for the past 2 weeks or so with nothing else changing on the car and no CEL's.
#4
haha a poll of a million different options. i dont have a vag, one of those "i shoulda bought one" things. im thinkin coil pack too but the guy didnt say a specific cylinder or anything. my car still runs fine and if it misfires its gotta be so quick to where i dont even notice it. it doesnt always run in limp mode. its weird it used to be full boost until after a couple pulls and then next pull its limp then other times i'd drive for ten minutes or so and the car would be in limp when i would pull and then other times it will be limp right away then be full boost twenty minutes of driving normally later. its really annoying...
Thread
Thread Starter
Forum
Replies
Last Post