My check engine light was on and I had a shop run the error codes which are as follows P1136 bank one & p1138 bank 2 sys lean. Also have P0441 and P0455. Any suggestion as to where to start checking these issue?

oops forgot to mention it's a 99 A6

look for a vaccum leak, that is what the problem normally is. By the way is it a 2.8 or 2.7T

Thanks Ted, I did check the vac lines the other day but did not see anything obvious. I will be looking againg today.

what kind of motor is it, i can tell the places they normaly wear out....

ted, its a 2.8 quattro any help would be appreciated.

Thanks

com2255

You're may not be able to "tell" if they are wearing out. You're better off just replacing them. The dealer should sell vac hose by the foot. A better alternative is to go to a porche dealer and buy theirs (3mm If i remember right). They last longer than the Audi stuff.

__________________

2004 VW Touareg
2005.5 Audi A4
1997 Audi A4

Thanks I will consider doing that although the hoses look like new. I have also thought about the purge valve being stuck open which may cause the lean condition (P1136 & P1138) and also the P0441 (incorrect purge flow) as well as the P0455 (large leak detectede mmission control system).

I also failed to mention that after feuling the car is difficult to start. It will crank and sputter to life only after feathering the gas pedal and getting the rev's up for about 10 to 15 seconds. I'm thinking this could also be a lean condition created by a malfunctioning purge valve.

Any comments on these thoughts?

com2255

Well without the car in my sight, i would say that you are on the right track. Let me know how it turns out. Ted

I replace the purge value ($140.00 from a local Audi dealer) took about 15 minutes. Went back to the shop and cleared the codes. I have about 25 miles on since clearing the codes and so far so good. No CEL yet, may have solve the problem. I'll post again if it comes back.

Thanks for the help it greatly appreciated.