Has anybody found a good spot to run a fat power wire thru firewall to hook up an amp? I finally got a amp but cant locate anywhere to run cable,nothing is visible,my friend said something about removing some plastic under hood to access but I havent been able to spend any time f-ing with it and my installers havent worked on my model car....

__________________
Broke FLA Cracka
98 A4 2.8 Quad 5 spd Black paint/Custom painted pin stripe(lol)
S4 grille, Alpine CDA9887,Kenwood 4 ch amp, 8 MB Quart mids/highs MMATS d2100.05 Amp-4 MTX 7500 12s
SRQ-FLA

run it into your ecu box, then through the grommet in the firewall

__________________
S4 bumper coming soon

i ran 0-gauge wire through the gap inbetween the fender panel... just unbolt it and slip the wire through, then bolt it back up.

__________________

ECU box
or
Hood Release cable grommet (remember to seal it up though)

__________________

I found a small gromet just to the drivers side of the center console just punch a hole in it and put it back

__________________
2000 A4 1.8T Quattro

Sparco//Infinity//GlowShift//6000k

Debadged//DualRearFogs//DIYVentGauge

hood release worked for me. seal that sh!t up real well after youre done tho (guerilla glue will last forever) or youll get tons of water in your cabin, like a river

__________________

http://www.audiforums.com/m_318162/tm.htm


ask and ye shall receive

__________________
- Colin

12v Proud

"Okay you f**kers, I'm going to tinkle now." - George Carlin

I've done them a bunch of times a the stereo shop I work at and did mine last week ran 0 awg through the rubber gromet that the ac lines come through the passenger sidetons of room and its sealed from the rubber.