Are you talking about the lower black molding? I am pretty sure you can get it at ECStuning but I am not sure. Also you can get them at the stealership.
Josh
__________________
Quote:
ORIGINAL: Leonardo DaVinci
"Once you have tasted flight, you will forever walk the ground with your eyes turned skyward, for there you have been and will always want to be."
Yeah the trim mouldings on the bottom of your doors car available at ECS Tuning for about $125/set. You don't have to remove the doors, but be ready for a PITA because they're held on by a steel bolt screwed into brass threads. [:@]
__________________
1997 Audi A4 2.8qm | Brilliant Black 12v FTMFW!
Yeah it's pretty simple; the onlytrick is getting the old bolts apart. Each trim piece slides into place from the back corner of the door, and then there's a bolt that goes through from the inside at the front corner that holds the trim piece in place. My old trim pretty much just rotted to the point where it fell off, leaving just a little bit at the front still attached to the bolts. So I drilled through the old bolts and got some new ones, plus washers and some anti-seize compound, and voila!
__________________
1997 Audi A4 2.8qm | Brilliant Black 12v FTMFW!
Same happened when I put my new ones on two weeks ago - there was some of the plastic from the lowers still on the bolt inserts, but it tore away and left just the thread inserts that the bolts were screwed into. I clamped on them with vise grips and then took them out via screwdriver on the inside of the door. It was kind of a pain, but not too bad.
Nope, you don't have to take the door panel off. Open the door and look way down in the lower front corner on the inside, and you'll see a screw there - that's the anchor screw for the lower. It's in the same place on all four doors.
door moldings
