Hello all! I just bought some RS4 replica rims for my 2000 A6 2.7T. The rims are 18x8.5 with a 38mm offset. I put on some 245-40-18 tires on them and my tires are rubbing against what I believe is the strut housing. Anyone else have this problem? If so, what size spacers did you use? I knew I should have gotten the 235's !! :-) Sorry, I tried to search it, but couldn't find anyone with the same tires and wheels.

__________________
2000 AUDI A6 2.7T
18" RS4 WHEELS - GUNMETAL
NO MODS

Where did you buy the RS4 replica rims? How is the quality etc?

__________________
2006 Audi A6 3.2 (Blue and Amaretto)
Tech and Premium Package
RS4 replica wheels
2005 Infiniti G35 coupe

I got them from velocity motoring. They are pretty nice looking rims. They look quality made.

__________________
2000 AUDI A6 2.7T
18" RS4 WHEELS - GUNMETAL
NO MODS

You didn't search too hard. I'm a regular poster and also run the Velocities RS4 replicas with 235's. No rubbing. See dimensions below.

__________________
2003 Audi A6 2.7T MT6
Premium Package-Cold Weather Package-Bose
GIAC-Bailey DVs-Samco TBB
AWE Stage 2 Clutch+Lightweight Flywheel
235/45 R17 Pirelli P6 All-season; OEMs
235/40 ZR18 ContiExtremeContact;
Velocity RS4 Replica Rims

Your probably running those 17's on the front right? I saw that post. Anyway, I have an update. What I thought was no clearance was actually a little bit of clearance. Very small. Only small enough to slide a piece of card board back and forth through it between the tire and that strut arm (i think thats what it is). Is that enough? Will the tire move with that arm? Or will it rub when I hit a bump? Thanks!

__________________
2000 AUDI A6 2.7T
18" RS4 WHEELS - GUNMETAL
NO MODS

Front right, front left, rear right, and rear left.

My winter rims are OEM 17" and I run the 18"Velocities in the summer.

__________________
2003 Audi A6 2.7T MT6
Premium Package-Cold Weather Package-Bose
GIAC-Bailey DVs-Samco TBB
AWE Stage 2 Clutch+Lightweight Flywheel
235/45 R17 Pirelli P6 All-season; OEMs
235/40 ZR18 ContiExtremeContact;
Velocity RS4 Replica Rims

I think I might just go with the 235s just to be safe.

__________________
2000 AUDI A6 2.7T
18" RS4 WHEELS - GUNMETAL
NO MODS

YOU need 235's, what kind of tire are you running.
Are you lowered? Sure you're not just rubbing against the liner? Check it with your fingers
With a 38ET and 8.5" wide rim, you can't put too big of a spacer, try a 5mm.

Also one of the screw holding the liner is at the top center of the fender, tires on lowered cars tend to rub against it. Remove it. it'll help.
BTW there is another thread giong these days about a uy who asked about 245's on 18's!

I got 245 Goodyear F1 As on my 18" DTM RS4 18 X 8 ET35 and they rubbed.. a lot! had them swapped for 235's.

__________________


2004 A6 Stg 2+ and 99 TJ...mod

The car is not lowered. It just barely clears the big arm behind the wheel. I just bought some Nankang nsII tires. Best bang for the buck.

__________________
2000 AUDI A6 2.7T
18" RS4 WHEELS - GUNMETAL
NO MODS

I would change to the 235's, I have a question though. What the heck do the numbers mean? I know the middle number is the inner number for the tire wall(18's use 40, 17's are 45 etc.) what is the first number is that the outer number of the ouside of the tire. So in theory you should not chang the first number unless you want more tire wall?

__________________
2000 A6 2.7t
Tiptronic
APR Chip, 710n DV's, K&N drop-in, 00022 tip re-code.
Planned: Nothing