Put me down for the dual nozzle kit! Please PM me price and all that stuff as well ASAP.
Josh
_____________________________
quote:
ORIGINAL: Leonardo DaVinci "Once you have tasted flight, you will forever walk the ground with your eyes turned skyward, for there you have been and will always want to be."
Hey, I am actually just going to get the single nozzle system... NOT the dual nozzle.
Josh
_____________________________
quote:
ORIGINAL: Leonardo DaVinci "Once you have tasted flight, you will forever walk the ground with your eyes turned skyward, for there you have been and will always want to be."
I can make pigs fly Posts: 14882
Joined: 12/14/2006 From: No longer Ohio Status: offline
Josh, i dont even think you could really run a single with decent results. You actually need a quad with that 2.7T
_____________________________
FACTS > followers 197whp and 292wtq with no chip on stock ic, airbox and catback AEG crank +Scat rods + 83mm Wiseco pistons = CincyTT Version 2.0T For sale - 20mm wrist pin pistons and rods $175 + sh
What??? Really??? hmm.... I have seen guys who put it right in front of the TB with the nozzle pointing towards it. Will that not work?
Josh
_____________________________
quote:
ORIGINAL: Leonardo DaVinci "Once you have tasted flight, you will forever walk the ground with your eyes turned skyward, for there you have been and will always want to be."
I can make pigs fly Posts: 14882
Joined: 12/14/2006 From: No longer Ohio Status: offline
It will, but you wont get any real cooling from it. The further away from the TB, the better it cools the iat's and the closer to the TB the more knock protection. If you did a dual, you can split the spray further back on each side to get more cooling also. If you had a i guess triple instead, you can have one by the TB and have 2 more just past each smic so you can gain tons of cooling w/o sacrafising any knock protection. You dont have to go this route, but 2 would be better for you and 3 would be ideal.
_____________________________
FACTS > followers 197whp and 292wtq with no chip on stock ic, airbox and catback AEG crank +Scat rods + 83mm Wiseco pistons = CincyTT Version 2.0T For sale - 20mm wrist pin pistons and rods $175 + sh
Set up a group buy on meth next. I found an ebay auction for a 55 gallon of 99.something percent pure methanol, buy it now of $200. We'll all pitch in, you measure it out into smaller bottles and send it out, sound like a deal? ; )
Will this benefit me without a BT? I have just a Revo Tune, 42DD DP, Blueflame Exhaust, Boost Machine, Mofo and a useless open air intake. I know it cools the intake charge but would I loose the Windshieldwasher tank in order to run this mod? Sorry for the dumb questions but I never had a Water/Meth injection unit and I am not sure if I would even gain any performance with my present set up. Thank for any advice as usual
Sure will! The cooler intake charge is gonna give you the ability to make more power with a stock turbo, AND as an added bonus, the injected water steam cleans your engine. It'll knock all the carbon deposits off the piston/valves and give you a clean running engine.
I can make pigs fly Posts: 14882
Joined: 12/14/2006 From: No longer Ohio Status: offline
a stock turbo is maxed out on power at 22-24psi and the w/m lets you increase timing to increase the power and keep hp up in higher rpms.
As for fluid, you can use ww fluid (its 25-40% meth depending on brand) but the dye may clog the nozzles over time. Not hard to clean if you choose this method. Or you can also go to autozone and get a few bottles of Heet, which is basically 95% meth and mix it with distilled water. I believe you can also get meth from paint stores in large amounts.
_____________________________
FACTS > followers 197whp and 292wtq with no chip on stock ic, airbox and catback AEG crank +Scat rods + 83mm Wiseco pistons = CincyTT Version 2.0T For sale - 20mm wrist pin pistons and rods $175 + sh
If I get meth from a paint store they will probably report me to the FBI for running a meth lab How difficult is one of those kits to install? And will you loose the use of your windshield washer resevoir to the meth thingy?
no you wont loosw the winshield wiper fluid you have the option to run it via that or run a seperate tank im running a sererate tank right behind the battery most likely
just this forum in the A4 sections and should prolly post on VW vortex...i dont wanna step on toes tho i think 25 people is do-able just from this forum....after a few more days if we dont have around 18-20 then i';ll post on VWvortex.com but feel free to send people over here if you know anyone....i will try to get better pricing if we shoot over 25.
_____________________________
225TT-AEMintake,R1 DV relo, Apexi TT,Samco TIP and boost hoses,dogbone kit,Awe boost gauge,RS4 rims,3.2 rear,SPEC 2+ clutch&steel FW. APR 93 chip,APR FMIC,19mm sway,Blueflame 2.75.Votex chin,Devils Own W/M,034 mounts and coilpack cover,4bar fpr,mofo,BM
Printable Version
RE: Group Buy Water/meth - 
How difficult is one of those 
