I need to replace my turn signal relay. I know there are some older posts that brush over the procedure; one even had pictures, but the links to the pictures are now broken. Can anyone explain how to replace the hazard switch/relay?
You first have to remove the radio and you need special keys for that. Then you should be able to remove the hazard switch after popping it out of the locking tabs. Been awhile since I've done one.
Use a flathead screwdriver or putty knife to partly pop off the wood trim, then pry it off with your fingers...pull it off little by little so it doesn't crack. Once the trim is off grab the edge of the hazard switch body with some needle nose pliers and pull it out of the dash (it will be tough to pull out) Once it's out, unplug the harness Install in reverse
Printable Version
Removing the Hazard switch/turn signal relay - 
