trunk button not working? (Full Version)

Audi Forum >> Audi Models >> Audi A6

trunk button not working?

  

johnstef -> trunk button not working? (5/5/2008 7:23:44 PM)

Just got a 2003 A6. though i press the trunk button on the key fob and nothing happens?? What can be wrong?


  
WeezyTT -> RE: trunk button not working? (5/5/2008 11:00:22 PM)

mine doesnt work either. i dont think it worked on my last audi either, both 02 a6

katcoota -> RE: trunk button not working? (5/6/2008 1:53:13 AM)

 
My trunk button used to work until the battery died. Subsequently when I reporgrammed it, I didn't do it quite correctly, so the trunk button stopped worked.

It's worth reprogramming the key fob to see if it fixes it. There is no need to go to the dealer for this (I think) but it depends on whether you have the imobilizer in the key fob or not. Mine didn't so it was not an issue.

Truthteller -> RE: trunk button not working? (5/6/2008 6:38:16 AM)

I thought my trunk button was not working until today. I figured out instead of just pressing it I had to press and hold it. Try that and I think you should be ok

johnstef -> RE: trunk button not working? (5/6/2008 5:38:09 PM)

i hold it down, and nothing? what can be the problem?

afstud6900 -> RE: trunk button not working? (5/6/2008 5:44:30 PM)

i have a 99 a6 and i just got a new keyfob and everything works but the trunk button on the keypad..on both of mine...but the guy at audi told me its not really suppose to cause of the handle on the trunk itsself and all you have to do is unlock the doors...but i dont know thats what i was told and im not worried about it.

ppgoal -> RE: trunk button not working? (5/6/2008 6:47:43 PM)

My '03 is off the road and covered.  But I vaguely remember all the button does is unlock the trunk.  You still have to reach under and open it.  Most American cars actually spring the trunk open when you "pop" it but not the German cars. 
 
But I could be wrong, too.

a6hcw -> RE: trunk button not working? (5/7/2008 7:02:35 PM)

On my 1996 A6 2.8L the wires to the push button in the glove compartment were broken, and a plastic lever on the trunk lock cylinder was broken. When I bought the car the truck would not open even with a key, so I worked thru the ski bag opening in the back seat to remove the latch keeper. The plastic link lever and switches from a redesigned newer used lock cylinder will fit on the older lock cylinder, so there is only one key. The lock cylinders are actuated by a vacuum pump under the rear seat, so check the vacuum line from the pump to the trunk lock cylinder. Look for a broken vacuum hose near the trunk hinge.
The night I picked this A6 up from the used car dealer, the sun roof popped open at a gas station when I locked the doors. So, another reason it doesn't work might be that the previous owners or their agents tampered with a few things.
Never buy any car with a bad engine, transmission, bent frame or other costly items.
The Bentley CD manual doesn't give much information on the truck lock cylinder with remote vacuum actuation. Beware of missinformation about not needing a shop manual, just because it doesn't cover everything.  

a6hcw -> RE: trunk button not working? (5/13/2008 9:41:40 PM)

On a 1996 A6 the two trunk switch wires at the glove compartment can fail behind the right hand rear glove compartment pivot and where they pass through a brass pivot pin with sharp internal edges. Also, these two insulated wires are too stiff for this application. Perhaps the plastic insulation hardened with age. The sharp internal edge may be removed from the brass pin with a sharp countersink tool. 

  

Page: [1]

Return to Audi Forums home page or view the Full Version of this page.