alright so i tried to use the search toolbar to find out how to remove the front bumper, and albeit i havent actually look at it on the car to try and see i was just trying to get a feel for it before i try and start taking it off etc as i am planning on doing a few mods in the near future that would require me to take it off (snub mount, hid conversion, and replacing the fog lights)

if anybody had any links or know how to take it off that would be great. Also is there anything i need to disconnect or be careful of when removing it?

thanks a bunch

__________________
2005.5 A4 2.0Tq 6speed

-Snub Mount
-Carbonio CAI
-Smoked side markers
-Smoked front bumper reflectors

nobody has anything?

__________________
2005.5 A4 2.0Tq 6speed

-Snub Mount
-Carbonio CAI
-Smoked side markers
-Smoked front bumper reflectors

Not sure about the snub mount. But for the lights you dont need to remove the bumper.

__________________
Toyota 4 runner

the snub mount should be further in the back of the bottom of the car ....around where the axles for the wheels would be but i haven;t looked yet

__________________
"America is all about speed; hot, nasty, bad ass speed" - eleanor roosevelt

ocadam, i know that you do have to take of the front bumper in order to change the foglights unless you have small enough hands to fit back there and do it that way, which i dont unfortunately

__________________
2005.5 A4 2.0Tq 6speed

-Snub Mount
-Carbonio CAI
-Smoked side markers
-Smoked front bumper reflectors

Removing and installing fog lights









Removing



–
Switch off ignition and take out ignition key.



–
Turn light switch to position “0�.



Audi A4:



–
Release retaining hooks -1...4- using a screwdriver -arrow- and pull off air intake grille in bottom section of bumper.









Audi S4:



–
Turn bolt -1- 90° (1/4 turn).



–
Detach air intake grille from fog light housing in direction of -arrowA-.



–
Then push air intake grille in direction of -arrowB- and simultaneously disengage retaining clip -2-.



–
Remove air intake grille.









All models:



–
Unscrew bolts -arrows-.



–
Disengage headlamp insert and remove.



–
Unplug electrical connector.



Installing



Installation is carried out in the reverse order; note the following:



–
Engage fog light on inside at bumper.



–
Adjust fog lights



Tightening torque








Component
Nm

Fog light housing to bumper
5








[IMG]local://upfiles/12092/D95EE71B33B040808F605FEC24D9011D.jpg[/IMG]

[IMG]local://upfiles/12092/ED12DC7547D84F9D914C3A537ADE5508.jpg[/IMG]

[IMG]local://upfiles/12092/248312D7F2E94527B6C6C0A6B8B9BC81.jpg[/IMG]

theres a write up for it you probably due have to have small hands. all look around for it.

__________________
Toyota 4 runner

got some DIY for every1 i forgot about this site. http://www.audidiy.com/b7a4.html

__________________
Toyota 4 runner

I could have posted how to remove the bumper but its only the fog lights that are the problem so the bumper doesn't need to come off

I cant see the pictures?

__________________