So I was going through some old stuff and found my old cold air intake from my last car. Took the hack saw out and cut it intoa few pieces, bought some clamps and set up a real cold air intake for my car. Took a few shots while putting it together....

Filter Location

...a better idea as to where the filter sits now...

...tube coming into the engine bay...


...finished product....

 

Keep it dry!

 

I dont think it will be bad with the under car shield and everything else...

 

Good point, as long as the noise insulator panel/splash guard is there it should be fine. Looks good though!

 

Yup. Good job! Now go dyno it and let us know about the massive hp/torque gains!

 

haha, should I be "that guy" who says I can really FEEL the difference? I'm sure its minimal if anything, but I figure its better than having that filter sit in the engine bay, and it cost me $12.