Just a quick question.

Where I work they rebuild turbo's, so...since I have a brand new KO4 in my trunk, I was wondering if there was anything I could do to it to get a bit more power out of it and still be able to run the PC-16 file with it? I posted this in general tech but didn't get much for hits, thought I'd try here. I want to p&p, ceramic coat, clip, and whatnot, but will my computer be able to compensate for the increased flo?

 

I dont think you can do much, you can take it apart and have the housing coated, that makes them flow a tad better and keeps the heat down..other than that i dont know..

 

hmmm, maybe i should must p&p the mani instead...think i'd get better gains from a p&p on my mani?

 

you can give it a shot, if you have the tools or can get it done cheep also install a test pipe.. get better spooli noticed a huge difference with my ko4 in my old car after a test pipe..

 

yeah definitely slappin on a test pipe when the turbo gets thrown on, also will be putting on custom 2.5" exhaust and fabbin up a CAI

 

sounds like what I did.. I used a magnaflow muffler sounded sweet.. 2.5inch is good, I think anything more with a test pipe would flow to much.. you need a little back presure.. with my set up i would chirp all 4 tires when the turbo spooled it was nice..

 

Yeah im using a magnaflow muffler too, I hope it sounds good. Im not going to have a resenator for a while, see how it sounds and go from there.

 

its definatly loud.. trust me.. louder then a borla set up, and it tends to drone a bit on the highway.. you will want a resinator after a few weeks

 

I can live with a little drone....hopefully the exhaust note and engine sound will cancel each other out lol. I'm sadly used to ricer drone so this shouldn't be too bad.

 

ha..you will like it then..