I've searched this site on how to take out the ACTUAL light bulb from the head light housing. Almost all the threads only talk about how to take the headlights out of your car and when it comes to the part to replace the bulb, people just sate, "REPLACE THE BULB". Well, yea buddy, that's what I'm doing, but I want to know HOW?? Please don't bash me about not searching and how there are many posts about this already. I have yet to find a thread that tells me how to take the the stock light bulb out. I have the head light out, I can take the low beam light bulb out, but there are wires attached to the light bulb. What do I do to the wires? I was thinking about just cutting them because I have a replacement HID kit, but for security reasons, I don't want to cut them incase I want to install the old ones back. Is there a way to disconnect the wires? I tried to take the headlight unit apart so I can see where these wires are going to, but I can't seem to get the housing seperated. Someone please help me?

 

well you know how to take it out...so reverse the steps and you know how to put it in! plug the light bulb into the socket type piece and line up the arrows and twist it in...as for the HID kit look it up if you want to install it

 

thanks

 

How can I take out the (HID) D1S Gas Discharge headlight bulbs (low beam) of an A 3 2006 2.0 T ? Cost @ dealer $ 200.00 ea. plus 55.00 installation.
Cost in some websites 86.00 to 100.00 ea. Flosser is 91.00, Sylvania is 100.00.
Part # N10566103.