Autozone tint is okay, and it's actually still good on the first car I did, but I got a different brand from Kragen, and you couldn't see through it when the sun hit it at an angle (dawn/dusk).

Question is: How do I get the rear molding off the rear window to get to the last bit of goo left behind the third brake light?
Is it something with those 2 rubber holes by the light??

Thanks in advance.

 

what percent was the tint? do you plan on having it professionally done or are you to familiar with tinting to need that?

 

It was 20% charcoal grey.. It was fine to see through in average light conditions. But I'm guessing it was the metallized layer somehow made it near impossible to see-through when the sun hit it from the side as if it were covered with dust. All the dark detail would lighten, and the light detail was hazy. I'm not a pro, but I'm pretty capable of peeling film and getting the bubbles out.

I'm just trying to get the rear brake light off so I can get the last bit of adhesive off from the edge around the brakelight, and maybe cover the entire window next time instead of having a cutout there.