Raiketsu

Junior Member

About Me

  • About Raiketsu
    Location
    Alpharetta, GA
    Interests
    Cars of course!

Statistics

Total Posts
Albums
Visitor Messages
General Information
  • Last Activity: Mar 27, 2010 12:50 PM
  • Join Date: Jan 21, 2010
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. screamin demons
    Jan 29, 2010 10:56 PM - permalink
    Reply on the LEDs.... They don't look so bad and the switch location was nice however the wires running out the door seal is just horrible. If you pop the hood and take the plastic cover off right near the windshield (that goes across the entire width of the hood). There is a place where the hood poping cable is ran. This has a large hole with a rubber grommet in place. I'd recommend you use this hole for the wires, as i use it for my amp power wire. Just make sure if you use it you re-seal it with something as when it rains water will leak BIG TIME through there.

    -Tyler

All times are GMT -4. The time now is 08:03 AM.