what would i have to do to recoding the ecu so that H box ecu works in any 6pseed car with ESP. 2001,
>>>> 2001.5, 2002.
CU, the
>>>> instrument cluster must be recoded. Re-
>>>> coding can only be done with a VAG scan tool,
>> such
>>>> as the Ross-Tech
>>>> VAG-COM that we distribute.
>>>>
>>>> To recode the instrument cluster:
>>>>
>>>> Step 1: Step 2: Step 3:
>>>>
>>>> Key off Remove engine ECU Key on
>>>>
>>>>
>>>> Step 4:
>>>>
>>>> Connect scan tool to car.
>>>> Press Instruments button.
>>>>
>>>>
>>>> Step 5:
>>>>
>>>> Press Adaptation button for instruments.
>>>>
>>>>
>>>> Step 6:
>>>>
>>>> Type in Channel Number 60 and press Read.
>>>> Change Stored Value from 0 to 1025 by entering
>> 1025
>>>> in New Value window and pressing Test.
>>>> Test Value will now read 1025.
>>>> Press Save and exit scan tool.
>>>>
>>>>
>>>> Step 7:
>>>>
>>>> Key off.
>>>> Install engine ECU with RSK04 chip installed.
>>>> Key on.
>>>> Clear all codes in engine ECU and Instruments.
>>>>
>>>>
>>>> If the instuments and engine ECU will not
>>>> communicate,
>>>> and value is verified as 1025 in channel 60 of
>>>> instru-
>>>> ment cluster adaptation, turn key off for a few
>>>> minutes
>>>> and then turn key on. The instruments ECU may
>> need
>>>> to fully power down to recognize the new value.
>>>>
found on awe tuning page is thi right

 

obviously if you took it off AWE's website it is correct....