yah dont worry, the performance parts will happen too, i just want to get my front bumper taken care of because it has a hairline crack right above the plate thats botherin me AND someone along the way drilled the plateholder into the bumper with woodscrews.

 

That's bootleg.

Everyone knows you use drywall screws for front bumpers.

 

I still refuse putting holes in my front bumper. Im suppose to have a front plate and my car has been in Ohio its entire life and still no holes drilled

 

yah, we dont even need the front plate here in PA, and yet im stuck with the holder on there unless i want half inch holes showing [:@]

 

That's why I didn't remove my empty plate holder until I got the euro plate.

The rivets for the plate holderare very soft, easy to drill through I used a 1/8 bit to get started, then I think a 3/16 bit to finish and the rivet head just came right off.

Quit wasting time and get a euro plate if you're in a state with no front plate requirement. It's money well spent IMO. Good looks, and covers the holes from the stock plate holder. Plus If you do get a front bumper in the future you can still use it.

From:

To:

 

ok so apparently there was already a thread about this kit, my bad for not searching thoroughly

https://www.audiforums.com/m_559401/tm.htm

that being said, they dont come to a conclusion on that thread either, so i went into one of the auctions for the kit that had ended and messaged someone who had purchased the kit to see if i could get any feedback on it from them. if he gets back to me, i'll post.

 

Good call, keep us updated.

A lot of us are in the same boat as you as far as that front bumper is concerned

 

yea i love it too, but its sooooooo expensive!

 

heres the response i got, unfortunately, it doesnt tell me much






Dear jsheezy44,





the fitment is not that great. And remember to watch out for shipping. It starts getting pricy.








- hhunted99

 

I wouldn't touch a cheap fiberglass kit with a ten foot pole. Fitment is gonna SUCK and if you so much as drop a screwdriver on it, more than likely you'll have spidercracked the whole damn thing.