header for 98 1.8t
#12
RE: header for 98 1.8t
ORIGINAL: InsaneHatter
AEB is good for 400bhp, on a safe side you can go lower...
400bhp = 312AWHP.
You would need to run a 2871R or higher before you open the engine to replace the rods.
after rods, you wont have a problem unless you have a bad tune.
AEB is good for 400bhp, on a safe side you can go lower...
400bhp = 312AWHP.
You would need to run a 2871R or higher before you open the engine to replace the rods.
after rods, you wont have a problem unless you have a bad tune.
#13
RE: header for 98 1.8t
ORIGINAL: onepoint8tee
Ya i mean whp. Arif runs the 2871R w/AEB and is at about 300whp w/out rods, but he just got a 3" exhaust so he may be closer to315 whp. Hopefully his rods will last because i dont think he has any intentions of doing internals.
ORIGINAL: InsaneHatter
AEB is good for 400bhp, on a safe side you can go lower...
400bhp = 312AWHP.
You would need to run a 2871R or higher before you open the engine to replace the rods.
after rods, you wont have a problem unless you have a bad tune.
AEB is good for 400bhp, on a safe side you can go lower...
400bhp = 312AWHP.
You would need to run a 2871R or higher before you open the engine to replace the rods.
after rods, you wont have a problem unless you have a bad tune.
I have intentions to do my inernals, if you help me
#14
RE: header for 98 1.8t
BTW he not running the 2871R i was talking about, he is running a 2871R Elim.. which is a 71mm compressor wheel in a 28R 2.5" inlet housing.
a full 2871R would yield more HP than a elim.
If you sticking w/ elim .. i woundt worry about doing internals...
If you are going bigger like say a 3071r, or 3076r, or 35r, then I would do internals.
a full 2871R would yield more HP than a elim.
If you sticking w/ elim .. i woundt worry about doing internals...
If you are going bigger like say a 3071r, or 3076r, or 35r, then I would do internals.
#16
RE: crankshaft?
stock crank is porbably ok but if your gunna go that far you mise well make it a 2.0 stroker, that would be bad a$$
ORIGINAL: zensane
wat kind of crankshaft comes in the aeb block,i am fully building an aeb motor so i need some info.thanks.
wat kind of crankshaft comes in the aeb block,i am fully building an aeb motor so i need some info.thanks.
Thread
Thread Starter
Forum
Replies
Last Post
ravger08
Archive - Engine/Performance Parts
1
03-23-2008 10:53 PM