been pritty busy with school and finally got around to putting in my tein springs. they were the 1.5 inch drop kit. i was pleased, the front is perfect and the back is just slightly lower than i wanted but nice overall. i was a little concerned about comfort but these springs are great. perfect balance between comfort and stiffness. i like the ride much better. handles well also. i also installed new strut mounts while i had them out so that my have added to it. and finally, NO MORE CLUNKING!!!

before



after



before



after



right





i need to take the rack off...and that ugly *** bumper sticker.



btw did i tell you guys my plan for the motor???



jk thats for my datsun

 

looks good. what kinda datsun u have? z series? my pops has a 71 240z with a jag V12 set up in it.

 

holy crap you needed those springs BAD. b4 the car looked like it was ready for sum offroading lol. car looks nice now

 

Drop looks good Im looking to lower my 02 a lil but I dont want it to tuck too much

 

yeah that b4 pic made it looked like it was raised!


looks good now!

 

its a 1972 datsun 240z, but its got a 2002 lm7 chevy v8. similar to the engine they put in thier 02 corvette only its bored to 5.3l rather than 5.7l. motor swaps are really common on datsuns cause they only wiegh like 2300 lb.

 

the springs will settle a little more too

 

they're guaranteed not to settle more than 5mm or it might have been 3mm...which i can deal with