my front bumper does not have holes in it and i want to put on my new european license plate, what should i do? drill holes?( i dont want to) or find some dealership sticky stuff and hope the works?

 

You will be better off with two tiny holes, than the epoxy glue or something that will damage the paint and finish of the bumper permanently. I hope you will get the license plate holder as well, without it, it will just look bad.

 

Look around for a banner on the forums here they sell Europlates and u can the frame to mount it too

 

yea, i have the holder, i think im just going to drill two little holes. thanks

what should i use to drill?

 

First measure and find the center position, mark the holes, then with a sharp instrument make little starter holes and then simply put in your screws with a hand driver about a quater of the way then take out and mount the bracket, making sure you fully but not overly tighten. You could always use a drill bit too, but make sure it's a small bit.