Just wondering how much you guys would expect to pay for a shop to do the following work on a 2001 225hp TT.

New connecting rods, Instalation of a new preassembled ready to go head, intake manifold installation, Turbo kit installation
FMIC/meth injection kit installation, Clutch/pressure plate/flywheel install, Exhaust install.

I would be supplying the shop all neccasary parts/gaskets for the install so just looking at labor cost, unfortanately I only have one shop to choose from because both the Audi custom shops turned down the job because im not using parts that they are dealers for.

If you guys could throw out some prices that would be reasonable for this work I would appreciate it I plan on doing the work myself if they try to charge me to much.

 

do it yourself, will save you the most

 

I wouldguess about $2k. Lots of that stuff will be done together. You might want to do some of that stuff yourself or with friends. fmic and w/m can be installed yourself.

 

I pmed a member about this not too long ago im not gonna say his name just because i dont know if he wants me putting this out there or not but he payed 3400 for the apr stage 3+ rods and brakes

 

I assume Labor Only?

 

yes labor only

 

so 8 grand..... including kit


hope they used lube

 

Then it will be about $4k then at the same shop. Subtract the brake job for a clutch job and that will make up the differnce.

That is assuming that the engine was pulled for the rod install. Also not counting in the w/m injection since that should be installed and tuned by owner.

 

yea engine was pulled for the install...

 

Then depending on labor hr rates, it should be $4k give or take $500