2 month plans
Just make sure your stock valve is installed the correct way, Audi installed it both ways but it will only work correct when pushing higher boost levels if it is installed with the side tube going into the turbo outlet hose(facing down). If it is installed the other way it will pop pretty quickly.
Yes Forge makes a splitter, its the same design as the GFB FX Stealth. Both are good valves. But if you want to go with a standard BPV then you want the 007.
Yes Forge makes a splitter, its the same design as the GFB FX Stealth. Both are good valves. But if you want to go with a standard BPV then you want the 007.
Thread Starter
|
1st Gear
Joined: May 2010
Posts: 65
From: VA
put it in 91.... correct me if im wrong. switch cruise into "on" then hold the button in till it flashes the tune you want from the blinks of the check engine. release and turn off car for 10 secs. start car and tune is set.
Step 1
Press and hold the "set" button on your cruise control. After approximately five seconds, the "check engine" light on your dash will begin to blink once per second. This will tell you that you are activating program one. This blinking sequence will continue for approximately five seconds.
After this five second interval, the "check engine" light will begin blinking twice per second. This will indicate that you have activated the second program. This process is continued to access any remaining programs you may have purchased. (three blinks = program three, four blinks = program four).
Step 2
Once you have activated the desired program, simply release the "set" button. The "check engine" light will stop flashing. Turn the ignition key off for 10 seconds, turn the key back on, and you will be locked in that program until you change it again.
It's that simple.
Press and hold the "set" button on your cruise control. After approximately five seconds, the "check engine" light on your dash will begin to blink once per second. This will tell you that you are activating program one. This blinking sequence will continue for approximately five seconds.
After this five second interval, the "check engine" light will begin blinking twice per second. This will indicate that you have activated the second program. This process is continued to access any remaining programs you may have purchased. (three blinks = program three, four blinks = program four).
Step 2
Once you have activated the desired program, simply release the "set" button. The "check engine" light will stop flashing. Turn the ignition key off for 10 seconds, turn the key back on, and you will be locked in that program until you change it again.
It's that simple.
Thread
Thread Starter
Forum
Replies
Last Post