Hey guys, got a quick question for you...

My Engine Temperature Gauge was not working so I bought a new sensor (the correct one) from ECS, replaced it as I finished up flushing my coolant, but alas my gauge is still not working.

Sometimes it kicks in when I start up the car, but it then it just slowly drops until it goes back to zero, also, sometimes it kicks in mid-drive, goes up to the halfway mark (where it should be) stays there for a few minutes, and ultimately dies back down. However, that is rare and most of the time the gauge is just dead.

Any suggestions?

Thanks in advance.

 

you should check the contacts on the cable make sure they arnt rusted

 

I did, they looked pretty clean. Any other suggestions? This is really baffling me.

 

check the connection for continuity?