Rear hub carrier bushings
#1
Rear hub carrier bushings
Rebuilding my rear suspension this spring. Got two pairs of bushings (number 4 below) for the bottom of the hub carriers. Yesterday I put in one new one in the vice. Squeezed right in. The one on the opposite side stopped at about 1/8 of an inch. Same on a bearing press. Tried one from the other pair, same problem. Finally banged it in with a 6 pound BFH.
What I did I do wrong? I've pressed a few bearings/bushings so I have some clue what I'm doing.
What I did I do wrong? I've pressed a few bearings/bushings so I have some clue what I'm doing.
Thread
Thread Starter
Forum
Replies
Last Post
jasonelement2010
S Car Model Line
1
08-02-2011 02:36 PM
Mott Power
Archive - Engine/Performance Parts
0
01-13-2010 04:20 PM