General Tech Good at troubleshooting? Have a non specific issue? Discuss general tech topics here.

180 degree spin <> Worn CV Joint - any link?

Old Jul 27, 2011 | 09:03 AM
  #1  
caseyjay's Avatar
Thread Starter
|
1st Gear
Joined: Dec 2010
Posts: 14
Default 180 degree spin <> Worn CV Joint - any link?

Hope I'm worrying over nothing but....

(note this is not in my A6 but my Honda Civic Aerodeck)

I've had a clicking CV joint for a few weeks now, normally only audible at low speed turns but in the past few days is apparent more often - am looking for a joint already to get this sorted.

This morning I did a 180 spin on a roundabout at about 35mph - front end lost all traction then trunk came round to meet me - luckily no-one hit me, no obvious damage. I was half expecting to see a problem with the axleshaft/joint but all seemed in order. It had been raining fairly hard this morning and there was some surface water but nothing major. I took off to a parking lot to test out drivetrain on full lock both directions and apart from clicking joint, no grip problems.

I've got to drive 250 highway miles tomorrow and I am hoping this was just a coincidence but wouldn't like to meet any similar traction problems at high speed.

My tyres are all very good, car is in good nick, just passed its MOT - this was my first time spin so would it just be a freak (greasy road, wet conditions?) accident? Naturally I am wary of the same thing happening again (and have more rain on the way).

Appreciate any advice...thanks
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Xin
New Member Welcome Area
0
Jul 23, 2015 12:08 AM
jinsojoo
Audi A4
0
Nov 11, 2009 05:59 PM
Wrona85
Audi A4
5
Oct 19, 2007 10:30 PM
rnbguy
Audi A4
3
Jul 28, 2006 09:27 AM
germancarmaniac
Audi A4
1
Jan 2, 2006 09:49 PM


Thread Tools
Search this Thread

All times are GMT -4. The time now is 06:09 PM.