2.8 wont start after clutch install...
#1
2.8 wont start after clutch install...
Hey -
Maybe you might have read that I was about to have a clutch installed in my 96 2.8. The clutch install went well except one problem....
The car cranks, but basically wont turn over. I suspected with my brother that the fuel wasn't being ignited.
After a power check, the spark plugs are not sparking but there is power going to the ignition coil....
Is the ignition coil the culprit? I need to replace this by sunday so I can drive back to college so any help is appriciate!
Thanks
Maybe you might have read that I was about to have a clutch installed in my 96 2.8. The clutch install went well except one problem....
The car cranks, but basically wont turn over. I suspected with my brother that the fuel wasn't being ignited.
After a power check, the spark plugs are not sparking but there is power going to the ignition coil....
Is the ignition coil the culprit? I need to replace this by sunday so I can drive back to college so any help is appriciate!
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
kinnes042
S4
5
04-10-2013 06:29 PM
brit.mike13
Audi A4
0
10-17-2010 08:26 PM