2005.5 Audi A4 3.2 B7 Tips Please!!
Hey guys I'm new to the forums, and I tried searching for some parts for my audi. However, ever time I search I seem to never find anything that can be applied to my car. I have a 2005.5 S-line A4 3.2. I was looking for a good exhaust and intake system to put onto the car. I just wanted to make the car sound better
. Thanks in advance for the help guys! Sry if this was already addressed! Just post the link to the original post and flame the hell outta this post lol...
. Thanks in advance for the help guys! Sry if this was already addressed! Just post the link to the original post and flame the hell outta this post lol...
I have a 3.2Qand unfortuntely were limited to mods. The only exhaust that is out there for the 3.2 is from Neuspeed and its made for the manual. With a little modification it will work on the triptronic. Miltech makes an exhaust for the 3.0 and someone mentioned that it will work with the 3.2 with some modification. As far as chips go I haven't found one yet.
i dont own 3L Audi, but i would hate to pay over $1000 for exhaust... if u wonna nice sound buy some nice catalyc, muffler... and take it to the local shop for custum 3" exhaust or even full dual exhaust system not a split (u have to get everythimg in pair) ... first u'll save some $$$$ (dont forget to tip me this this info) and u'll have nice sound....

u dont have to pay over $1000 for system like this... single parts dont cost that much... and u'll pay around $500 for 3" piping and nice labor.
just an idea... good luck...

u dont have to pay over $1000 for system like this... single parts dont cost that much... and u'll pay around $500 for 3" piping and nice labor.
just an idea... good luck...
The difference is all the piping on the expensive one is mandrel-bent stainless steel.
Cheaper custom piping that you are talking about is not. If it is stainless, and mandrel bent, it wont be any cheaper having a shop make you one than if you had bought a pre-made setup.
It basically will outlast the life of the car, so its worth it.
Cheaper custom piping that you are talking about is not. If it is stainless, and mandrel bent, it wont be any cheaper having a shop make you one than if you had bought a pre-made setup.
It basically will outlast the life of the car, so its worth it.
Thread
Thread Starter
Forum
Replies
Last Post




