Getting ready to pull the a6's engine next week, it will be going under the knife and getting a new TC and upgraded valve bodies, considering swapping steering wheel and self cancelling ring at the same time so I can have some paddle shifters. I plan on pulling most accessories off the top and polishing whatever I can get my hands on. I am going with VAST performance products for the TC and level 10 for the valve bodies. After I added the water/meth kit the TC began to slip at high RPM and under full boost, I always knew it was going to happen. Now it's time to take care of things before I get my full stage 3 custom tune from VAST. I will let you know how things work out.

Cheers
Ryan

 

Sounds great. Good luck with it all. Post some pics...

 

How much for the work? I will need this aswell shortly

 

work will be done by me, so zero dollars labor, total on parts should run about 2k, it may end up being a little more if I find things worn that need replacing

 

that isn't to bad.. damn where are you located maybe I could pay you for my job ;P or might get audi to do it

 

nm Calgary Alberta