Audi A6 Transission Limp mode
#1
Audi A6 Transission Limp mode
Hello
Here's the problem that i'm experiencing.
my car 2001 A6 FWD trans code EZZ
About few months ago check engine went on, and transmission went into a limp mode, I hooked up to Vagcom scanner pulled out following codes. Couldn't really understand what was going on, erase the codes and it went back to normal
Now, check engine is back on, codes are erasing, and still show up these messages
Here's the codes that i have
18032 - MIL Request Signal Active (Check TCM for errors too!)
P1624 - 35-00 - -
17090 - Transmission Range Sensor (F125): Implausible Signal
P0706 - 35-00 - -
I installed a new neutral safety switch, but the problem is still exist
any suggestions?
thanks in advance
Here's the problem that i'm experiencing.
my car 2001 A6 FWD trans code EZZ
About few months ago check engine went on, and transmission went into a limp mode, I hooked up to Vagcom scanner pulled out following codes. Couldn't really understand what was going on, erase the codes and it went back to normal
Now, check engine is back on, codes are erasing, and still show up these messages
Here's the codes that i have
18032 - MIL Request Signal Active (Check TCM for errors too!)
P1624 - 35-00 - -
17090 - Transmission Range Sensor (F125): Implausible Signal
P0706 - 35-00 - -
I installed a new neutral safety switch, but the problem is still exist
any suggestions?
thanks in advance
Last edited by dub; 02-25-2010 at 07:13 PM.
Thread
Thread Starter
Forum
Replies
Last Post