In-dash Cup Holder Face
Thread Starter
|
1st Gear
Joined: Aug 2008
Posts: 63
In-dash Cup Holder Face
My '01 1.8T is coming together.
A replacement central locking pump in en route, as is a new LF inner door handle. My mechanic is cleaing the contacts on the hazard warning relay to get the turn signals sorted out.
I am in need, however, of the in-dash cup-holder face or facade, with the illustration on. The cup-holder works fine, but somehow the front panel has been broken off. Perhaps if someone has replaced a broken one . . .
After these matters are addressed I will need to repair the LF headlight washer, but I am not sure what I'll need other than the cap, which is missing.
I have called the dealer (!) for a fax of the front bumper schematic, but it was in one ear and gone. If anyone has a schematic to show what parts I'll need to amass, I'd appreciate seeing it.
Finally, I'd like a recommendation on a part number or source for new logo mats. The mats in the car are rubbish.
Thanks in advance for any tips . . .
A replacement central locking pump in en route, as is a new LF inner door handle. My mechanic is cleaing the contacts on the hazard warning relay to get the turn signals sorted out.
I am in need, however, of the in-dash cup-holder face or facade, with the illustration on. The cup-holder works fine, but somehow the front panel has been broken off. Perhaps if someone has replaced a broken one . . .
After these matters are addressed I will need to repair the LF headlight washer, but I am not sure what I'll need other than the cap, which is missing.
I have called the dealer (!) for a fax of the front bumper schematic, but it was in one ear and gone. If anyone has a schematic to show what parts I'll need to amass, I'd appreciate seeing it.
Finally, I'd like a recommendation on a part number or source for new logo mats. The mats in the car are rubbish.
Thanks in advance for any tips . . .
Thread
Thread Starter
Forum
Replies
Last Post
derek2079
Archive - Interior/Electrical/Stereo
0
Jul 9, 2005 07:03 AM
