Well I installed the new control arm and torqued everything to specs. Will drive it tomorrow (hopefully) to see how it goes. Only mishap was I put a small nick in the CV boot about 1/2 in or so in from the clamp on axle shaft side. Not happy. I wrapped the crap out of it in rescue tape - temp fix.. Do yo know of anything I can apply that will seal it up and be flexible. How about that flex seal stuff? Thanks.

 

I wouldn't worry too much about the boot.If it starts clicking down the road (and it annoys you enough), then replace the axle.

 

I can't wait till you figure it out because I have the same identical problem with my 98 Audi. When its cold no noise..when its hot it makes that same noise. Good Luck

 

Update: Finally drove the car.. still really hot out here at 6:30 (105). And it appears to be fixed. I hear no noise. And can I say I am relieved and (been so long trying to figure it out) that I will go out to the car sometime and will hear it again - lol. It was a bad part from day one. Taiwanese crap.. I specifically asked for European parts and got them except for that one. Should have insisted on a replacement when I received it. No problem now as it is done.

A4TurboGuy a BIG shout out to you and HUGE THANK YOU and appreciation for all your help and ideas.

 

My pleasure brother. I'm glad I was able to help you get it figured out.

.