2016 S3 wont start after harness troubleshoot
Thread Starter
|
1st Gear
Joined: Jan 2021
Posts: 2
2016 S3 wont start after harness troubleshoot
My reverse light/rear turn signal went out, but the bulbs were fine. I decided to take a digital multimeter and verify there was voltage to the reverse light harness. There was voltage so I'm guessing my reverse light/turn signal is bad. When I put it all back together and tried to start my car, it wouldn't start! Instead, multiple errors pupped up; "Audi Pre Sense Fault" "Break Malfunction" "Hill hold assist unavailable" "TPMS" etc...I've checked every fuse, they're all fine. I've disconnected the battery for 20 min and reconnected it, and it still wont start. I have already had the Passenger Seat Airbag recall fix. I'm at a loss here, anyone have any idea what might be the issue?
Thread
Thread Starter
Forum
Replies
Last Post
gumbase
Computer & Fuel Systems
1
Dec 14, 2012 01:26 PM
AJPTransport
Audi A4
0
Jun 8, 2009 02:40 PM
Baumee8
General Tech
1
Nov 18, 2006 10:49 PM
