3.1 tranny oil in front. rear???? & missfires
#1
3.1 tranny oil in front. rear???? & missfires
Getting ready to change the tranny fluid, I read in the FAQ it takes 3.1 assuming it all drains out,
but what about the fluid on the rear..
I am NOT talking about the Haldex.
1. Year of car-2001
2. Model of car- ----------audi tt q 225
3. What engine & TIP or 6sp - 6spd
4. Miles 80000
5. FWD or Quattro -q
6. Any CELs or stored codes -no
.
.
------I am sure most of you know this all ready
I was getting over 200 missfires with VAGCOM on cylinders 2 and 4,
then flashing CEL at hight RPM. VAGCOM said CEL was multiple missfires
so I got new spark plugs and coil on packs to fix the problem.
during the proces I checked my wires and found this:
I used electrical tape and some high temp glue and bundled it all up.
Those wires are cylinder 2 & 4! I guess I need a new harness too..
but what about the fluid on the rear..
I am NOT talking about the Haldex.
1. Year of car-2001
2. Model of car- ----------audi tt q 225
3. What engine & TIP or 6sp - 6spd
4. Miles 80000
5. FWD or Quattro -q
6. Any CELs or stored codes -no
.
.
------I am sure most of you know this all ready
I was getting over 200 missfires with VAGCOM on cylinders 2 and 4,
then flashing CEL at hight RPM. VAGCOM said CEL was multiple missfires
so I got new spark plugs and coil on packs to fix the problem.
during the proces I checked my wires and found this:
I used electrical tape and some high temp glue and bundled it all up.
Those wires are cylinder 2 & 4! I guess I need a new harness too..
Last edited by FRMAR28; 04-30-2009 at 10:17 PM. Reason: pics
Thread
Thread Starter
Forum
Replies
Last Post
brent07
Audi A4
6
09-06-2005 02:38 AM
Project D
Archive - Exterior/Body
0
10-30-2004 03:37 AM