audi 100 loses turbo boost pressure
#1
audi 100 loses turbo boost pressure
an audi 100 2.5tdi loses boost pressure momentarily at full boost, there is a fault code "manifold pressure too high". The MAP sensor is new. I have measured the wastegate control valve to be performing normally, I have not been able to accurately measure boost pressure, as I believe it should be 1.8- 1.9 bar ,but my gauge only goes to 1.5 bar.
Is there anyone that has had this problem, or knows the answer? Help!
Jarvis
Is there anyone that has had this problem, or knows the answer? Help!
Jarvis
Thread
Thread Starter
Forum
Replies
Last Post
Clos2010
B6 Models
2
09-03-2013 08:15 PM
kidislegit
All Other Audi Models
0
04-09-2011 11:02 AM
03a418tnate
General Tech
0
08-10-2010 08:07 PM