I posted this in the TT section but got no hits.
2002 TT Roadster.

Need info on what is needed to lift up switch panel to right of brake handel to replace Nav Switch. I worked on avionics in the navy but this aint quite the same. And besides , this is mine, not the governments lol.

Picture embedded in link.

https://www.audiforums.com/m_449660/tm.htm

 

Are you sure the replacement is the switch, or the whole panel?

If it's the whole panel ( it should be) then just remove the whole panel, unhook the wires & replace.

 

I got a response on the Bentley site (from the book guy) saying that the whole console comes off and the switch is removed after tabs(?) are released . He said its on page 91-11. I ordered the book but will have to wait a while to see what he was talking about because I got "super-saver" shipping.

The Audi parts and service dept ordered just the switch so I guess its just the switch.

 

I figured this out, wasn't too tough after all. I just pulled up on the broken switch and it came out. Then found a plastic snap lock on plug to release switch from cable and pulled it off. Then snapped on new switch and snapped it back into console.tadah