Cam lock bar Measurements
Thread Starter
|
1st Gear
Joined: Jan 2007
Posts: 12
RE: Cam lock bar Measurements
ORIGINAL: Vlok
I did it without the bar. But I have a shop and many tools at disposal, I make my own. The bigger holes should be horizontally facing eachother just a hint. If you bend those valves or if you have a hard time accelarating don't come crying .
I did it without the bar. But I have a shop and many tools at disposal, I make my own. The bigger holes should be horizontally facing eachother just a hint. If you bend those valves or if you have a hard time accelarating don't come crying .
Thread Starter
|
1st Gear
Joined: Jan 2007
Posts: 12
RE: Cam lock bar Measurements
ORIGINAL: HP Addict
No one here is with holding information from you, im sorry we havent been able to help you thus far. Apparrently everyone who has seen this thread dose not own on. Get started, take some measurements and just make the bar quickly while you have the front end apart. It only looks like you would need the distance between those 2 bolts, the bending of the bar seems to be arbitrary. GO FOR IT!
No one here is with holding information from you, im sorry we havent been able to help you thus far. Apparrently everyone who has seen this thread dose not own on. Get started, take some measurements and just make the bar quickly while you have the front end apart. It only looks like you would need the distance between those 2 bolts, the bending of the bar seems to be arbitrary. GO FOR IT!
Thread
Thread Starter
Forum
Replies
Last Post
