Dampner Pully move while trying to change Timing Belt
Thread Starter
|
1st Gear
Joined: Jun 2010
Posts: 163
Dampner Pully move while trying to change Timing Belt
Trying to do the Timing belt job and im on the step where you remove the dampner pully........
Its very difficult to remove as the bolts are extremely tight and my friend cannot manage to hold it properly straight while im trying to unscrew the four 6mm hex bolts. The Dampner pully moves a bit but not a whole lot.
Everything is still connected.(Timingbelt tensioner pully crank &camshhaft).
Did we screw up or is everything fine?
Its very difficult to remove as the bolts are extremely tight and my friend cannot manage to hold it properly straight while im trying to unscrew the four 6mm hex bolts. The Dampner pully moves a bit but not a whole lot.
Everything is still connected.(Timingbelt tensioner pully crank &camshhaft).
Did we screw up or is everything fine?
Thread
Thread Starter
Forum
Replies
Last Post
ASN
B6 Models
4
May 27, 2010 09:41 PM
