anyone have expirence with FCP Grouton upper control arms $75?
#1
anyone have expirence with FCP Grouton upper control arms $75?
i have 2 a6's in need of upper control arms. labor is 300 for each car with free alignment.
i looked through some websites and found these. a guy posted something about these same arms over at audi zine and they seemed to be impressed.
has anyone tried these out? do they wear out quick? since i only got 59k off my oem im not expecting these to go too high as it seems to be a common failure in the c5 chasis.
i looked through some websites and found these. a guy posted something about these same arms over at audi zine and they seemed to be impressed.
has anyone tried these out? do they wear out quick? since i only got 59k off my oem im not expecting these to go too high as it seems to be a common failure in the c5 chasis.
#5
i use FCP quite a bit. for my a4 2.8, s4 4.2, and now a6 4.2. Service are good, parts quality is ok for the price. If u install them PROPERLY. it'll last 40k km without problem. But if the installation was not properlly, 2-3 month whatever brand or OEM audi will fail again. As these arms intend to fail around 40-50k in good road condition, and 20-30k in bad road condition like Toronto, ON, canada. I would like just go cheap, and change them regularly. For the whole set, I can finish in about 4hours now.
Thread
Thread Starter
Forum
Replies
Last Post
jdahlen24
DIY - Do It Yourself
0
08-25-2011 03:05 PM