valentine one - how do install
Thread Starter
|
1st Gear
Joined: Jan 2007
Posts: 236
From: NJ, ocean shore
valentine one - how do install
here is, how did i hard wired my A6.
1. I used fuse #8 to connect live wire (red one).
2. For negative (ground) wire use any screw on chassis.
3. here is located Direct-wire power adapter. (Don't forged for easy acces to Direct-wire power adapter fuse.)
4. Slide Power cord under the window trim ( hide power cord )
5. Here is, where is mounted my V1. The best place is center - top corner of the windshield. Don't position it so that it "looks" into the rearview mirror
Enjoy !!
PS: don't forget, if u buying valentine one on ebay, ALWAYS check serial number at http://www.valentine1.com/upgrades/for available upgrades. Some times people selling unit for 300$ what's need upgrade for next 200$ !!! So, remmember, new unit cost 399$
1. I used fuse #8 to connect live wire (red one).
2. For negative (ground) wire use any screw on chassis.
3. here is located Direct-wire power adapter. (Don't forged for easy acces to Direct-wire power adapter fuse.)
4. Slide Power cord under the window trim ( hide power cord )
5. Here is, where is mounted my V1. The best place is center - top corner of the windshield. Don't position it so that it "looks" into the rearview mirror
Enjoy !!
PS: don't forget, if u buying valentine one on ebay, ALWAYS check serial number at http://www.valentine1.com/upgrades/for available upgrades. Some times people selling unit for 300$ what's need upgrade for next 200$ !!! So, remmember, new unit cost 399$
Thread
Thread Starter
Forum
Replies
Last Post
