date & time keeps resetting
#11
Try this -it's from my old D3
-------------------------------------------------------------------------------
Address 61: Battery Regul. Labels: 4E0-910-181.lbl
Part No SW: 4E0 910 181 C HW: 4E0 915 181 C
Component: J0644 BEM H12 0510
Revision: 00000000 Serial number: 00000000000204
Shop #: WSC 05146 444 83888
VCID: 2045EAAC8A45
Part No: 4E0 915 105 A
Component: von VA0 2603280968
Coding: 344530393135313035412056413032363033323830393638
Shop #: WSC 09222 444 53302
No fault code found.
-------------------------------------------------------------------------------
Address 61: Battery Regul. Labels: 4E0-910-181.lbl
Part No SW: 4E0 910 181 C HW: 4E0 915 181 C
Component: J0644 BEM H12 0510
Revision: 00000000 Serial number: 00000000000204
Shop #: WSC 05146 444 83888
VCID: 2045EAAC8A45
Part No: 4E0 915 105 A
Component: von VA0 2603280968
Coding: 344530393135313035412056413032363033323830393638
Shop #: WSC 09222 444 53302
No fault code found.
#14
just to make sure I do this correct
here are the steps that I performed: (I am on version 11.11.5, module 61)
- open module 61, select 07 Coding
- The energie manager is shown on option 0, select option 1, which is the battery
- Click the battery coding button
- fill in part number, serial number and select the correct battery, click ok.
- back to window and click do it. I get the error Coding rejected etc.
If I then click on the coding button again, I get an additional error:
vscderror
Cant spawn
;
;----------------------
;
;
0010,0,General
001,1,Generator Voltage,(specified)
001,2,Battery Voltage,(actual)
001,3,Dynamic-Field,Signal
001,4,Load,Response Time,Display Range: 0....9 sec
;
002,0,Battery Temperatur4E0915181C VA0000000204
And an OK button
Almost looks like the Audi system will not accept any coding
- open module 61, select 07 Coding
- The energie manager is shown on option 0, select option 1, which is the battery
- Click the battery coding button
- fill in part number, serial number and select the correct battery, click ok.
- back to window and click do it. I get the error Coding rejected etc.
If I then click on the coding button again, I get an additional error:
vscderror
Cant spawn
;
;----------------------
;
;
0010,0,General
001,1,Generator Voltage,(specified)
001,2,Battery Voltage,(actual)
001,3,Dynamic-Field,Signal
001,4,Load,Response Time,Display Range: 0....9 sec
;
002,0,Battery Temperatur4E0915181C VA0000000204
And an OK button
Almost looks like the Audi system will not accept any coding
Thread
Thread Starter
Forum
Replies
Last Post