First I want to apologize for the hack job I have going on here LOL I had to figure out which cable was what from the aftermarket alarm. After all is good I'll solder them and organize them.

Here's my current issue:

Aftermarket alarm arms and locks the doors ( locks go down, windows roll up. ) but when I hit the unlock button... it disarms the alarm ( cabin lights turn on, lights flash ) but the locks won't come up. Heres the funny part if I hit the unlock button on my drivers door it pushed the locks up and the doors are unlocked. What am I doing wrong?

Pics:

Dropbox - wires

let me know if you need more high def pictures.


Also, I read a thread about a week ago saying I had to bind the two White and Black wires from the car's harness to the factory disarm. Is it possible I blew a fuse? but in that case would the lock work?

 

You use the same wire for disarm and unlock. If you send one pulse to that wire, it will disarm the alarm. If you send a second pulse to that wire, it will unlock the car. Check your manual that came with your keyless entry and it should tell you how to set it to send a double pulse. Also, check out this link because it will be a lot of help. Also, I don't know if you've been this far but if it tells you that a wire you need is located in the trunk at the factory alarm module, you don't actually have to go to the trunk to get them. Every wire it said I had to go to the trunk to get I was able to find in the bundle of wires under the back seat.