B6 Models Please discuss all 2002 - 2005 B6 A4 topics here...

Serious Ignition Issues

Thread Tools
 
Search this Thread
 
Old Aug 14, 2012 | 05:25 PM
  #1  
JJC123's Avatar
Thread Starter
|
1st Gear
Joined: Sep 2011
Posts: 1
Default Serious Ignition Issues

2003 Quattro 1.8T. About a month or so ago, I noticed it was missing-mostly at idle. I drove 400 miles on highway and it was fine the entire time. Pulled into the parking lot at my destination and immediately started missing. I jumped out and checked the coil packs by pulling the connectors one-by-one. The misfire was on the second cyl. The CEL was obviously flashing as well indicating a miss. I hooked up the ODB II and it confirmed the miss on the 2 cyl. The plugs had maybe 1500 miles on them, so I assumed it was the coil pack. I replaced the coil pack on the 2 cyl. This did not fix the miss. I replaced the spark plug with a new one-that did not fix the miss. The plug was wet with fuel, so I rulled out the injector. I replaced all 4 coil packs-that did not fix the miss. I then determined since it was not the plug, coil pack, or injector, it must be the connector/wire. I ordered a repair kit and replaced the connector. I also checked all fuses and they were fine. Now the car will not even start. I'm at a loss for what it could be now and just dropped 2k to fix sludging. I'm trying to sell it as I've bought a truck, but I'd like to get it in running condition in order to do so. Any and all advice would be greatly appreciated. Thanks a lot.
 
Old Aug 15, 2012 | 03:43 AM
  #2  
headstart101's Avatar
1st Gear
Joined: Aug 2012
Posts: 12
From: Bay Area, CA
Default

Good luck bro, this forums is about as usefull as a Honda forums to figure out what is wrong with your Audi....
 
Old Aug 15, 2012 | 06:06 PM
  #3  
pa4ul's Avatar
4th Gear
Joined: May 2007
Posts: 3,413
Default

was your cel still flashing after u replaced the cylinder 2 pack or was it solid? After u replaced the coils did u scan again to see what comes up now?
 
Old Aug 15, 2012 | 07:44 PM
  #4  
Audi Tek's Avatar
Tech Certified
Joined: Jul 2009
Posts: 779
From: Connecticut
Default

most likely a vacuum leak.

Knock sensors sit right next to cylinders 2 and 4 so they usually the cylinders the record misfires during vacuum leaks.

I'd be looking for a broken check valve on the breather coming off the back of the valve cover.
 
Old Aug 15, 2012 | 07:47 PM
  #5  
Audi Tek's Avatar
Tech Certified
Joined: Jul 2009
Posts: 779
From: Connecticut
Default

Originally Posted by headstart101
Good luck bro, this forums is about as usefull as a Honda forums to figure out what is wrong with your Audi....
You can always PM one of the people listed in the Tech Certified sticky.

My PMs go straight to my work email..... I don't always have the time to browse every post on every forums, I'm sure its the same for other people as well
 
Old Aug 15, 2012 | 08:39 PM
  #6  
headstart101's Avatar
1st Gear
Joined: Aug 2012
Posts: 12
From: Bay Area, CA
Default

Originally Posted by Audi Tek
You can always PM one of the people listed in the Tech Certified sticky.

My PMs go straight to my work email..... I don't always have the time to browse every post on every forums, I'm sure its the same for other people as well
Well I will do that next next time....Sorry for the rant!
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Dylanamer
Audi A6
1
Jun 26, 2014 10:54 PM
tofast2belast
B6 Models
1
Sep 19, 2012 06:08 PM
audiA4gm
B5 Models
3
Sep 6, 2008 02:57 PM
CCA4
B5 Models
3
Jun 25, 2008 06:28 PM
GeilKyle2
Audi A4
0
Sep 13, 2005 12:09 AM




All times are GMT -4. The time now is 01:25 PM.