Help clutch install problem?
#1
Help clutch install problem?
After installing the new flywheel and clutch kit (RS4 conversion kit) from ECS it seems as if the trans axle is not engaging in the clutch. I have the car almost all the way back together and I can still spin the axle shafts and drive shaft by hand in any gear. I have done several clutches in jeeps and I have never seen this before. Is there something in the tans axle that is allowing the shafts to spin freely? Any suggestions before I tare it back apart?
Thanks in advance
Thanks in advance
Thread
Thread Starter
Forum
Replies
Last Post
Matt_Iliketurbopull
Audi A4
13
05-01-2007 05:28 PM
Matt_Iliketurbopull
General Tech
2
04-28-2007 03:06 PM