I have a 02 6 speed and with the engin running and the clutch pushed in it will not go into gear. When the car is off i put it into gear and held the clutch in to start the car when it started with the clutch in it would start to go but i could not get it out of gear until the car was off. i know i need a new clutch and was wondering which clutch to use and if i should put in a light weight fly wheel or oem. i have an apr chip, bi-pipe, intake and plan on other performance up grades. also how much would it cost to get installed.

 

man, I feel you man, I have the same problem right now too. Im just hoping its not my clutch but the master cylinder.

 

probably the slave cylinder on the gearbox needs bleeding check your break fluid level it feeds the slave cylinder

 

Hano had the same problem. Ended up being a loose bolt holding the shift linkage in. So check that out, too.