If you are that set on not putting any holes in it, buck up & spend the $550 for some e-codes. [:@]

 

i would rather spend that money on a chip. it was just a question to see if it could be done beacuse it seemed like it was a better route than putting holes in the housing.

 

Like I mentioned before,
http://lightwerkz.net/products.htm

 

http://audizine.com/forum/showthread.php?t=14104

this is what i followed when doing it...good luck...looks alot better without the orange..and then just get clear bulbs cause the ones that were in mine were orange bukbs just swap them out and bada bang bada boom you got clear corners...

 

Putting your headlights in the oven is not a better route than drilling a small hole in the back that gets filled with caulk.

 

I did mine the conventional way, the only problem is that I scratched up the clear plastic on the inside of the light a little bit when sliding the amber piece out. I also filled the little holes with silicone. I dont think id put mine in the oven haha id probably mess it up.