P1392 Camshaft Pos.Sensor,Bank2 Open Circ./Short to B+

 

Yikes get your car looked at. I would not drive it again. Could be a bad camshaft sensor or timing belt slipped a tooth. Is the car running fine?

 

looks like a bad sensor or harness.

 

i have not driven it since the CEL came on a few days ago. last night i ran vag-com, got that code and cleared it. this morning i started it up for the first time since the CEL came on, and it ran rough for a few seconds then i shut it off. CEL was still on.

 

Are you able to do your own maintenance? Replacing the camshaft position sensor is pretty easy.

 

yeah sounds like something i can handle. hopefully i can find one locally so i can install it this weekend.

thanks for the info

 

just replaced sensor, no change still trips code and CEL is back.

timing belt is only 3k miles old, think it could slip a tooth?

any other thoughts?

 

If that code is accurate, I would imagine that that wire goes straight to the ECU, might do a "quick" continuity check from the cam sensor to the ECU. You'd have to get some extra wire to extend the range of your multimeter (assuming ya got one).